Our Product Research Team
At Crutchfield, you'll get detailed, accurate information that's hard to find elsewhere.
That's because we have our own in-house Product Research team — they open the box,
verify contents, check the owner's manual, and record dimensions, features and specs.
We stay on top of new products and technologies to help people make informed choices.
Amplifier: The power output from the built-in amplifier is
150 watts RMS (450 watts max). The amplifier is counter sunk into the back panel
of the enclosure (the heat sink fins protrude approximately 3/8").
Note: Neither speaker wire, RCA interconnects,
nor amplifier wiring kit (power/ground/turn-on wires) are included.
Signal Input: The amplifier has both speaker level (harness)
and line level (RCA) inputs. The input sensitivity range is 50mV-4V for the line
inputs and 400mV-16V for the speaker inputs.
Crossover: The amplifier's low pass crossover point is
continuously variable from 40 to 200 Hz; the crossover slope is 12 dB/octave.
Bass Boost: The bass boost circuit provides a variable (0-12
dB) signal boost centered at 45 Hz.
Status LEDs: There are two status indicator LEDs on the
amplifier. A green LED lights to indicate the amplifier is turned on and
operating normally. A red LED lights to indicate the amplifier's protection
circuitry has been activated. The protection circuit activates and the
amplifier shuts down when the input voltage (power) is too high or too
low, when the amp overheats, and when there is a short between the amp
- Width: 22-1/2"
- Height: 14-5/8"
- Depth (bottom): 12"
(the grille adds approximately 2-1/8",
for a total of 14-1/8")
- Depth (top): 9-1/8"
Remote Level Control: The included remote level control
lets you adjust the output level of the amplifier from the front of the vehicle.
It can be mounted under the dash, in the glove compartment, etc, and has the
- Width: 1.625" (2.55"
including the mounting flanges)
- Height: 0.775"
- Depth: 1.525" (2.028"
including the knob and cable)
- Auto Turn-On: two position switch; on/off;
when using the speaker level inputs the amplifier will turn on
automatically when it senses an input signal
- Phase: two position switch; 0° or 180°; the
sub's phase can be easily inverted
- Crossover Frequency: rotary knob; set the
low pass crossover point; continuously variable from 40 Hz to
- Bass Boost: rotary knob; continuously
variable from 0 to +12 dB
- Level: rotary knob; continuously variable
from 50mV-4V (line level) or 400mV-16V (speaker level)
- Remote Bass: RJ-25 jack for use with
the included remote bass level control
- Fuse: a single 25 amp ATO style fuse
protects the amplifier
- Line Input: stereo RCA jacks (female)
- Speaker Input: 4-pin plug for use with
the included harness
- Power Input: screw terminals for power,
ground, and remote turn-on; each will accept spade terminals
up to 0.325" wide (approximate)